De-3D Movies: A Guide To Making Your Own 2D-Glasses

By Eric Eisenberg 2011-05-04 23:56:09discussion comments
fb share tweet share
Thereís a laundry list of things that I donít like about 3D. It raises ticket prices by four dollars; makes every movie dimmer; the glasses are incredibly uncomfortable (especially for a prescription glasses wearer like myself) and studios are spending millions developing a technology that nobody seems to want. None of those problems compare to the worst one of all, however: the headaches and nausea.

While it should be noted that not everyone suffers from these afflictions while watching 3D movies, a large cross-section of audiences do. The symptoms are caused by each eye being presented with a different image and results in strain that can cause pain or motion sickness. Due to lack of options or groups of friends that have no issues with the 3D experience, many have been stuck suffering in 3D theaters nationwide. Now you can try to change that.

A couple weeks ago I stumbled on to a site called 2-DGlasses.com. The site sells, for $10 each, glasses that actually can convert 3D movies into 2D movies. Studying the concept, I realized that the glasses could actually be pretty easy to build by oneself instead of buying a pair of pre-made ones. Below you will find a five-step instruction manual to making your own De-3D glasses. Sure, they donít solve the dimness problem, you still have to shill out the extra money and they are still annoying to wear, but at least you can enjoy the movie-going experience more comfortably.

Step 1: Gather Your Supplies
For this project you will need only a few things: two (2) pairs of 3D glasses; one (1) utility knife (the smaller the better); and extra-strength adhesive. Your work space should be clean and stain-proof.



Step 2: Cutting The First Pair Of Glasses
Using your utility knife, cut out one of the lenses from one pair of 3D glasses Ė at this stage in the game it doesnít matter if you cut out the left or right side. The key, however, is that you want to leave a small rim of the lens intact. This rim needs to be wide enough that you can apply extra-strength adhesive to it, but narrow enough that it doesnít disrupt your field of vision.



Step 3: Cutting The Second Pair Of Glasses
After youíve cleaned up the blood and bandaged all of your cuts from the utility knife, itís time to move on to the second pair of glasses. Do not - I repeat DO NOT Ė cut out the same lens that you did from the first pair of 3D glasses. If you cut out the right lens in step 2, cut out left lens here, and vice versa. This time around, you do not want to leave a rim. Instead, cut as close to the frame as possible so that you have the largest surface area you can get.



Step 4: Putting In The New Lens
Again, clean up the blood as it can smudge the lenses and make the adhesive less effective. Take said adhesive and apply around the rim of the glasses from Step 2. The key is to not use too much. Take the cut-out lens from Step 3 Ė which you will need to flip in order to fit Ė and place it in the empty lens from the back and hold it firmly for 30 seconds or however long it takes to let the adhesive dry.



Step 5: Head Off To The Movies
Provided youíre not ready to pass out from blood loss or need to rush to the hospital because youíve severed your index finger, youíre now ready to enjoy your 3D movie in glorious 2D. Feel free to tap the shoulder of the guy in front of you and tell him that you wonít be vomiting all over the back of his head thanks to Cinema Blend.


discussion
Subscribe To Topics You're Interested In
Comments
blog comments powered by Disqus
Back to top
RELATED
FROM THE WEB
NEW REVIEWS
FEATURES
TOP MOVIES
HOT TOPICS
TRAILERS